Sunday, February 26, 2012
Have a part number for 2004 Buick Rendezvous lug nut covers ?
They are gray plastic and look like a lug nut. They cover the nut and have threads that keep the wheel cover on. There are 5 per wheel. Thanks!Have a part number for 2004 Buick Rendezvous lug nut covers ?the dealer stocks themitalian translation to english
How to replace the solenoid on a 1994 Buick LeSabre?
I need step by step instructions on how to replace the starter solenoid on a 1994 Buick LeSabre?How to replace the solenoid on a 1994 Buick LeSabre?pull the starter, remove the one bolt holding the last wire that goes to the starter motor, pull the two screws out that hold the solenoid to the starter. twist the solenoid and slide it off. installation is pretty much reverse order.
03 Buick LeSabre is making a loud rough noise seems to be coming from under the driver's side?
Someone mentioned could be a wheel bearing or trans bearing. Noise is directly under driver's side and gets louder the faster I go.03 Buick LeSabre is making a loud rough noise seems to be coming from under the driver's side?it does sound like a wheel bearing. A wheel bearing noise is often described as a roaring noise. A bearing often will get louder when making a turn at speed in one direction and quieter in the other direction. Make sure you have a safe place to check that because you will be swerving back and forth.
1992 buick roadmaster 5.7 runs hot when pulling hills fan clutch has been replaced?
I have noticed a small seep of anti freeze from the front of the intake.Radiator seems to be circulating good.Any one having had this problem and was able to fix it.1992 buick roadmaster 5.7 runs hot when pulling hills fan clutch has been replaced?at the front of the intake, is where the uupper hose connects to the thermostat housing. you may have a loose radiator clamp at that junction might. try tighting the clamp on the upper hose, at the housing. with you loosing temp. pressure, your thermostat will not regulate the water temp. properly. be sure that you have your anyifreeze, and water in the radiator mixed properly, 50/50, half water, half antifreeze. also , be sure you have a good 5/30 sae motor oil in the ctrankcase. I would start with the upper hose at the thermo. housing. good luck!!1992 buick roadmaster 5.7 runs hot when pulling hills fan clutch has been replaced?any seep is a bad sign, where antifreeze leaks out air enters, and air heats faster than water your coolant is likely becoming airated, shake a water bottle up this is airation but coolant reatains the bubbles better, it may be a thrmostat gasket (o ring) replace the O ring seal make sure you clean the surfaces, and refill. a presure test wouldn't hurt either.
1998 buick lesabre custom 3.8 wont start i took the starter to oreillys its bad got a new one still made same?
noise got a bigger battery still making the same cllicking noise what else could be the problem?1998 buick lesabre custom 3.8 wont start i took the starter to oreillys its bad got a new one still made same?If its making a clicking noise ever time you try to turn the car over, you have a problem wioth either the starter, battery, alternator or igintion and electrical wiring. Did you install the starter correctly and make sure everything is tight? CLicking usally have something to do with the selonid in the starter or a bad battery. Is the bigger battery new? you could have possibly two bad batteries. Lastly you may have a bad alternator or selonid in the alternator.
try jump starting the car as well.1998 buick lesabre custom 3.8 wont start i took the starter to oreillys its bad got a new one still made same?Try cleaning the insides of your battery cable terminals. A dark gray color indicates oxidation that can severely inhibit current flow from the battery to the starter motor.
Get a battery brush at any auto parts store and use this to clean all surfaces that mate up to the battery posts. Clean the battery posts as well, tighten the terminals and start the vehicle.
Note: If you've been trying to start the vehicle for a while you may need to charge your battery prior to starting.
try jump starting the car as well.1998 buick lesabre custom 3.8 wont start i took the starter to oreillys its bad got a new one still made same?Try cleaning the insides of your battery cable terminals. A dark gray color indicates oxidation that can severely inhibit current flow from the battery to the starter motor.
Get a battery brush at any auto parts store and use this to clean all surfaces that mate up to the battery posts. Clean the battery posts as well, tighten the terminals and start the vehicle.
Note: If you've been trying to start the vehicle for a while you may need to charge your battery prior to starting.
1989 Buick Century Custom bogs down when accelerating?
I changed the fuel filter, air filter, plugs, plug wires, Distributorless system, changed the coil, changed the tranny filter and fluid. Still bogs down when pressing the accelerator, Idles fine once started, but can take a bit to get it started. Any Ideas out there?1989 Buick Century Custom bogs down when accelerating?You seem to know a good bit, so I'm going to throw some advanced ideas your way (as well as a few other simple ones).
1) Check the throttle cable tension.
2) Change the O2 sensors.
3) Change the MAF sensor.
4) Check fuel pressure (bad pump).
5) Change the fuel injectors.
6) Check throttle body operation.
7) Have the catalytic converter replaced.
8) Run a compression test.
9) Change the ECU.1989 Buick Century Custom bogs down when accelerating?Check the fuel pressure with a fuel pressure gauge.
My bet...low fuel pressure,bad fuel pump.1989 Buick Century Custom bogs down when accelerating?REPLACE THE I.A.C.MOTOR. THE IAC.MOTOR STANDS FOR IDLE AIR CONTROL. WHEN YOU STEP ON THE GAS, THIS VALVE CLOSES, SLIGHTLY TO GIVE THE ENGINE MORE INRICHMENT, OR MORE POWER. THIS VALVE ALSO, AT COLD MORNING STARTS, ACT AS THE OLD BUTTERFLY, ON A CARB. ENGINE. IT SHUTS OFF ALL THE OUTSIDE AIR, AND GOES FULL INRICHMENT, FOR QUICK START UP. CHANGE THE I.A.C., AND YOU WILL HAVE YOUR BRAND NEW 89, BACK. GOOD LUCK BUD!!!!1989 Buick Century Custom bogs down when accelerating?
If its a 3.3L, there a 2 big things to check. First fuel pressure. Key on engine off spec if 40 -47 Psi. Second, the IAC could be a concern. Had one happen to me, held the gas to the floor just to bring the engine to any RPM.augsburg college
1) Check the throttle cable tension.
2) Change the O2 sensors.
3) Change the MAF sensor.
4) Check fuel pressure (bad pump).
5) Change the fuel injectors.
6) Check throttle body operation.
7) Have the catalytic converter replaced.
8) Run a compression test.
9) Change the ECU.1989 Buick Century Custom bogs down when accelerating?Check the fuel pressure with a fuel pressure gauge.
My bet...low fuel pressure,bad fuel pump.1989 Buick Century Custom bogs down when accelerating?REPLACE THE I.A.C.MOTOR. THE IAC.MOTOR STANDS FOR IDLE AIR CONTROL. WHEN YOU STEP ON THE GAS, THIS VALVE CLOSES, SLIGHTLY TO GIVE THE ENGINE MORE INRICHMENT, OR MORE POWER. THIS VALVE ALSO, AT COLD MORNING STARTS, ACT AS THE OLD BUTTERFLY, ON A CARB. ENGINE. IT SHUTS OFF ALL THE OUTSIDE AIR, AND GOES FULL INRICHMENT, FOR QUICK START UP. CHANGE THE I.A.C., AND YOU WILL HAVE YOUR BRAND NEW 89, BACK. GOOD LUCK BUD!!!!1989 Buick Century Custom bogs down when accelerating?
If its a 3.3L, there a 2 big things to check. First fuel pressure. Key on engine off spec if 40 -47 Psi. Second, the IAC could be a concern. Had one happen to me, held the gas to the floor just to bring the engine to any RPM.
What is the torque specs for a 2005 Buick Rendezvous front wheel bearing?
bad ABS sensor on front passenger side 2005 AWD Buick Rendezvous. must change wheel bearing and need torque specs.What is the torque specs for a 2005 Buick Rendezvous front wheel bearing?if you mean the axle nut then all i do is put all my weight on a breaker bar and cheater pipe to tighten it. they never came loose.
Subscribe to:
Posts (Atom)